Research Guidance
|Ph.D. Thesis| |Master's Thesis|

Master's Theses Supervised

(i) Devulapalli Balaji (1989); Thesis topic:" Mathematical modelling of combination blown steelmaking processes."

(ii) Amarendra Kumar Singh (1990); Thesis topic:" Mathematical modelling of thermal fields during heat treatment of steel"

(iii) Chaitanya Bhanu(1997); Thesis topic: "Hydrodynamic modelling of steelmaking tundish systems"

(iv) Rakesh Kumar (1997); Thesis topic: "Modelling of mixing and mass transfer phenomena in gas agitated reactors" ( Co-supervisor: Prof. B.Deo, Dept. of MME, IIT, Kanpur)

(v) Asish Robert (1998); Thesis topic: “Mathematical Modelling of flow and Residence Time Distributions in different tundish designs" .

(vi) Kamalesh Mandal (1998); Thesis topic: "Physical and mathematical modelling of flow and mixing in CAS systems with large aspect ratio"

(vii) Binod Bihari Mahato (2001); Thesis topic:"Modelling of flow and mixing in gas stirred ladle under transient conditions

(viii) Projit Mitra (2001); Thesis topic: “Mathematical Modelling of three dimensional turbulent flows in some steelmaking operations

(ix) Santosh K Rout (2001); Thesis topic: "Modelling of steady and transient flows in gas stirred ladle systems"

(x) Jayanta Mandal (2003); Thesis topic: "Mixing times in ladles stirred with dual porous plugs"

(xi) D. Satish (2003); Thesis topic: "Flow, mixing and mass transfer  in dual plug stirred ladles in the presence of an upper buoyant slag phase"

(xii) M. Madan (2004); Thesis topic: "Numerical simulation of flow phenomena in rotating viscometers”

(xiii) D.Chatterjee (2005): Thesis topic “ A computational and experimental study of  fluid flow phenomena in a hollow jet Nozzle”

(xiv) Sujoy Patil (2005): Thesis topic “ Mixing models for slag covered ladles”

(xv) Rajeev K Singh (2007): Thesis topic “Mathematical Modeling of fluid flow, mixing and hydro0dynamic refractory wear in gas stirred ladles for different bottom designs”

Ph.D. Dissertations Supervised

(i) Shiv Kumar Choudhary (1994) Thesis topic:" A study on fluid flow, heat transfer, morphology and macro segregation in continuous casting of steel" (Co-supervisor: Prof.A.Ghosh, Met.Engg.)

(ii) Anil Kumar (2005) Thesis topic: “Physical and mathematical modelling of flow and Residence Time Distributions in a multi strand continuous casting tundish” ( Co-Supervisor: Prof. S.C.Koria)