2012-2014: Naval Research Board, New Delhi, PI: Arun K Saha

• Synthetic Jet Actuator for Drag Reduction of Underwater Vehicles.

2010-2013: Department of Science and Technology, New Delhi, PI: Kamal K Kar

• Development and Performance Evaluation of Carbon Nanocoil Structure for the Catalyst Support in PEM fuel cells.

2010-2012: Indian Space Research Organisation, Bangalore, PI: Kamal K Kar

• Development of Carbon Nanotube Coated Backing Structure/Bipolar Plate (Exfoliated Carbon Nanostructured Reinforced Phenolic Nanocomposites) for the PEM Fuel Cells: Performance Evaluation.

2008-2011: Naval Research Board, New Delhi, PI: Arun K Saha

• Synthetic Jet for Propulsion and Maneuvering of Underwater Vehicle.

2008-2010: Aeronautic Research and Development Board, New Delhi, PI: Arun K Saha

• Experimental Studies of Flow and Heat Transfer in a Rotating Ribbed U-Duct with Detached Ribs.

2006-2008: Indo-Swiss Project, Department of Science and Technology, New Delhi,  PI: K. Muralidhar

• Quantitative Analysis of In-Vivo Magnetic Resonance Imaging Data for Diagnostics of Vascular Disease Supported by Computational Fluid Dynamics Simulations.

Consultancy:

January 2006-July 2006: Lohia Starlinger Limited, Kanpur, PI: Arun K Saha

• Experimental and CFD ANALYSIS OF HOT-AIR OVEN.

2005-: Mech-Well Industries Limited,  PI: Arun K Saha

• Simulation of flow and transport of fly ash through an electro-static precipitator.

September, 2000-September, 2004: (Post Doctoral Research) Department of Mechanical Engineering, Louisiana State University, Baton Rouge, LA, 70803 USA. 

• Numerical Simulation of Flow and Heat Transfer Through Turbine Blade Tip and Techniques to reduce Blade Tip Leakage.

• Computations of Flow and Heat Transfer Through Micro Heat Exchangers.

• LES and URANS Study of Flow and Heat Transfer in a Rotating Ribbed Duct of Different Aspect Ratio.

• Numerical Simulation of Endwall Heat Transfer in a Turbine Blade cascade. 

July, 1999- August, 2000: (Post-Doctoral Research) Department of Mechanical Engineering, State University of New York at Stony Brook, Stony Brook, NY, 11794 USA. 

• Integrated Modeling, Design and Control of Crystal Growth Problem.

1994-1999: (Ph.D.) Department of Mechanical Engineering, Indian Institute of Technology, Kanpur, India. 

• Dynamical characteristics of the wake of a square cylinder at low and high Reynolds numbers.

1992-1994: (M.Tech.) Department of Mechanical Engineering, Indian Institute of Technology, Kanpur, India. 

• A multigrid method for two and three-dimensional flows behind bluff bodies in a channel.